Peugeot 308 Key Fob Replacement
Peugeot's 308 might be getting on a little however, it's still eye-catching. It's not the most luxurious car in its class, but it is an enjoyable and comfortable drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is intermittent or constant the following tips will assist.
Water Damage
If you leave your fob in a puddle or splash it with water when kayaking, swimming, canoeing, rafting, or canyoning, it's likely to sustain water damage. The best way to avoid this from happening is to always keep it in a dry container when you're outside or performing things where the fob might be exposed to excessive amounts of water.
It's also important to make sure that the fob has dried out prior to opening the fob and then use it. If you detect any odors emanating from the fob (such as industrial liquid or windshield washer fluid) it is a indication that it's submerged.
A wet circuit can cause the battery's energy to drain or even explode. If you can pull your keyfob 308 from the water you need to turn the button side up and shake as much water out as you can prior to opening the casing. Remove the battery, then wipe the circuit board clean using a cotton swab that has been submerged in 90 percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not function include a dead coin-cell battery, receiver module problems signal interference, or a malfunctioning chip. If none of the above is the problem you can restart the system by removing the 12 volt battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system that allows drivers to start their vehicle from the distance, allowing them to warm up or cool down the car before they enter. This feature is extremely beneficial, especially during winter's cold and chilly months. However, it is possible that the remote start system stops operating due to a range of reasons, like a dead coin battery.
A coin-shaped battery that is found inside the key fob can last for a period of between two and four years, based on how frequently it is used and where it is purchased. The date of use is printed on the package or marked in the user's manual.
If the key fob has stopped working after exposure to clean tap water then you must remove the battery, clean the chip using a paper towel and isopropyl alcohol, then dry it thoroughly before replacing it. If the key fob has been exposed to soapy or salty water, it may have caused the chip to be damaged. You will need to replace it.
If you're not certain the battery is in good condition You can test the voltage with a multimeter set to the vehicle's voltage range and connected to the terminals for minus and plus. The voltage should be around 12-13 volts but if it is lower, the battery should be replaced. peugeot 107 replacement key cost G28 can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should begin to run after this.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, then it's possible the receiver module has created a fault. It's that part that sends an alert to the car when your key fob is activated, it also acts as an immobiliser, and stops it from starting unless the correct key is present.
This could be caused by a number of reasons, such as water damage or simply aging. If your Peugeot 308 key fob has been exposed dirty tap water, for instance the electronic chip located inside is damaged. In this scenario, you'll need to take it out and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and try it again.
If the issue is not resolved, it is a good idea to consult an area Peugeot expert or locksmith. They can employ the diagnostic tool to identify the issue and fix it.
It is stressful to lose your Peugeot car key. A professional auto locksmith will be able to solve the issue in minutes. They can program your vehicle and cut a new, functioning key for you. Click here to locate the nearest locksmith.
Faulty Electronic Chip
The electronic chip that is in the Peugeot 308 key fob is an important part of the remote control system. If it is damaged your car may not start or you might receive a message stating "anti-theft active". If this occurs, the only option to fix the problem is to purchase a new key. Luckily, auto locksmiths who are professionals can complete the task in the shortest time.
The chip in the chip of your Peugeot 308 key fob can become faulty due to water damage, sweat dirt, or other causes. If your Peugeot 308 key fob has been exposed to soapy water, you must take it to the cleaners immediately. You can make use of a paper towel and isopropyl alcohol for cleaning the electronic component. After that, you should allow the battery to completely dry.
Radio interference can cause a key fob to cease working. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects in the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you have this problem.
The Peugeot key fob 207/308 is extremely delicate and requires a lot of care. You should not drop it or throw it around. If you lose it, try to locate it as quickly as possible. You can reset your on-board computer by disconnecting the battery for a couple of minutes. Be sure to disconnect the negative first, and then the positive.